: Default
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
40 Terminating System in Mode A
for incoming C.O. calls
02
03
04
08
09
10
11
12
14
16
18
21
23
31
Trunk Line (Direct) Appearance
Trunk Line (Direct) Appearance + TAS
Direct-In Termination
Dial-in
Automated Attendant
Attendant Console + TAS
[8300R2]
Attendant Console + Trunk Line
(Direct) Appearance
[8300R2]
Attendant Console + Trunk Line
(Direct) Appearance + TAS
[8300R2]
Termination to Attendant Console
[8300R2]
Remote Access to System (DISA)
ISDN Indial
(for receiving maximum 8digits dialed
number)
ISDN Indial
(for receiving complete dialed number)
Enblock Dialing Method
(for Forced On PBX)
[8300R7] [For EU]
DID, Tie Line and the call which is not
handled by the PBX
CM30 Y=18
CM30 Y=05
CM49, CM64
41 Terminating System in Mode B
for incoming C.O. calls
NOTE 1: When data 02, 03, 11 or 12 is assigned, set CM30 Y=18 to 0.
NOTE 2: For DIDs and Tie Lines, set CM30 Y=02 and CM30 Y=03 to 31.
NOTE 3: When data 18 is assigned, the maximum dialed number can be received in ISDN Indial differ with
command as bellow.
- When using CM76 Y=00, the maximum dialed number is 4 digits.
- When using CM76 Y=90, the maximum dialed number is 8 digits.
Continued on next page
To Next Page
Loading...
