: Default
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
004 Answer signal from distant
office for outgoing connec-
tion
0
1
2
3
7
Answer signal arrives (12 kHz, 50 Hz Metering
signal) (C.O. line)
Battery Reversal (C.O. line)
Answer signal arrives
(Tie line/ISDN/CCIS/SIP)
No answer signal arrives
(Polarity Reversal is ignored and answer timing
shall be set by CM41Y=0>03)
No answer signal arrives (Tie line/No metered
C.O. line, Answer timing shall be set by CM41
Y=0>03)
CM41 Y=0
005 Release signal from distant
office for outgoing connec-
tion or incoming connection
0
1
No release signal arrives
(Ground Start/Loop Start C.O. line without
Release signal)
Release signal arrives
(Tie line/Ground Start/Loop Start with Release
signal/DID/ISDN/SIP)
008 Sending dial pulse on outgo-
ing call
1
2
3
No dial pulses are sent out (Speaker Paging)
Dial pulses are sent out: For test
(Release the resister/sender when the calling
station is on-hook)
Dial pulses are sent out (C.O. line/Tie line/
Radio Paging)
009 Incoming connection signal-
ing
See PRECAUTION (2)
01
03
04
05
06
08
15
Ring Down (Ground Start C.O. line)
Wink Start/CCIS/SIP
Delay Dial
Immediate Start
2nd DT/Timing Start-Tie line
ISDN
Ring Down (Loop Start C.O. line)
CM35 Y=020
010 2nd DT sending on call
termination
0
1
Not sent (DID, etc.)
To send
Continued on next page
To Next Page
Loading...
