: Default
Y SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
276 ISDN Alternative Routing
for Remote Unit in survival
mode when receiving trunk
call
0
1
Allow
Restricted
277 Call Completion to Busy
Subscriber (CCBS) for a call
originating office
[For EU]
0
1
Allow
Restricted
278 Call Completion to Busy
Subscriber (CCBS) for a call
termination office
[For EU]
0
1
Allow
Restricted
279 Pattern number for adding
an access code for outgoing
call to the calling number
stored by Message Reminder
when terminating a tandem
call via CCIS/SIP trunk
0
7
NONE
Pattern No. 0
Pattern No. 7
No data
CM50 Y=11
281 Calling party number relay-
ing in ISDN to ISDN/CCIS
to ISDN connection (for
incoming trunk route)
[For EU]
0
3
To provide
Not provided
CM35 Y=282
NOTE 1: This command must be set for incoming trunk route.
NOTE 2: Calling party number relaying in ISDN tandem connection is available when both CM35 Y=281 and
CM35 Y=282 are set to 0.
Continued on next page
To Next Page
Loading...
