Chapter 1 HOW TO USE CAT
1-25 NWA-033623-001 Rev.8.1
91ch1001.fm
CAT OPERATION
The examples of data setting are described below.
(1) Example in the case that station number 300 is to be assigned to Physical Port No. 010101 and station
number 301 to Physical Port No. 010102 by CM10 Y=00.
Example of CAT Operation
NOTE 1: When no data exists, “NONE” is displayed. And when data exists, that data is displayed.
NOTE 2: This operation is for confirming the data assignment. You can omit this step.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
STEP 9
STEP 10
STEP 11
STEP 12
STEP 13
STEP 14
Set CAT mode.
Press ST .
Enter "1000" (Command Code).
Press DE .
Enter "010101" (Physical Port No.).
Press DE .
Enter "300" (Station Number).
Press EXE .
Press DE .
Press S .
Enter "301" (Station Number).
Press EXE .
Press DE .
Lift handset, then replace it.
CAT MODE
COMMAND =
COMMAND = 1000
1000 >
1000> 010101
1000> 010101: NONE−
1000> 010101: NONE−300
OK
1000> 010101: 300 −
1000> 010102: NONE
1000> 010102: NONE−301
OK
1000> 010102: 301
(Display)
NOTE 1
NOTE 2
NOTE 1
NOTE 2
JULY/17/2009
To Next Page
Loading...
