NEC Univerge SV8300 - Page 40

Chapter 1 HOW TO USE CAT
1-26 NWA-033623-001 Rev.8.1
91ch1001.fm
CAT OPERATION
(2) Example of correcting the data entry
In STEP 5 in the above (1) example, when has been pressed after entering “010102” by
mistake, press . Then the state returns to STEP 4.
STEP1: CM10 Y=00 has been entered and has been
pressed.
STEP2: “010102” has been entered instead of “010101” as
intended.
STEP3: “010102” has been assigned as the first data after
pressing .
STEP4: If is pressed, the state returns to that of Step 1.
STEP5: Enter “010101”.
STEP6: Press , and assign the correct first data.
If, in Step 11 in the above (1) example, when “302” has been entered instead of “301”, press .
Then the cursor moves to the position of “2”.
STEP1: In Step 11, enter “302” instead of “301” as intended.
STEP2: Press .
STEP3: Press digit Key “1”.
DE
CE
DE
1000>
1000>010102
1000>010102: NONE
DE
CE
1000>
1000>010101
DE
1000>010101: NONE

1000>010102: NONE-302

1000>010102: NONE-30
1000>010102: NONE-301