Chapter 1 HOW TO USE CAT
1-30 NWA-033623-001 Rev.8.1
91ch1001.fm
ERROR MESSAGES
Error Messages
NOTE: Depends on the command entered, either one of two error messages is displayed.
ERROR MESSAGE MEANING OF MESSAGE ACTION
WRONG The data stored in the memory is
wrong. This message is displayed
when too many digits are entered.
For example, when assigning “123”
for a service access code when “12”
has been already used for another
service access code.
Clear the present data by entering
“CCC”, or enter the correct data.
SEE CMxx YYYY Double assigned error of the same
station number or trunk number.
The station number or trunk number
intended is already assigned to first
data YYYY of CMxx. Confirm.
USE CMxxxx The data is already assigned by
another command.
The command code and YY number
already assigned are displayed. Con-
firm.
TRK NOT ASSIGNED The designated trunk is not assigned. Assign the trunk by CM10.
WD ERROR Error exists in memory. Check the second data to register and
enter the correct data.
MEMORY FULL Memory allocation disabled when
using finite memory with plural com-
mands.
Check the number of data registered.
To Next Page
Loading...
