3-427 NWA-033623-001 Rev.8.1
91ch3005.fm
COMMAND CODE
TITLE:
GROUP CALL, MY LINE NUMBER THAT DISPLAYS THE CALLING NUMBER,
SERIAL NUMBER WITHIN THE CONFERENCE GROUP, CONFERENCE PILOT
STATION FOR THE OUTGOING CALL, PILOT STATION FOR THE SERVICE
ORIGINATING CALL FOR EACH TENANT, SUITE ROOM GROUP NUMBER
57
FUNCTION:
This command is used to assign the Group Call numbers and stations for Group Call by Pilot Number
Dialing, and the My Line number that displays the calling number, the Serial number within the Confer-
ence group, the Conference Pilot station for the outgoing call, the Pilot station for the service originating
call for each tenant, the Specification of Suite Room group number.
PRECAUTION:
None
ASSIGNMENT PROCEDURE:
DATA TABLE:
ST
EXE++ +
+
57YY
DE
++
DE
2ND DATA
(1-8 digits)
1ST DATA
(2/4/5 digits)
: Default
Y 1ST DATA 2ND DATA
No. MEANING DATA MEANING DATA MEANING
10
29
Group Call No. 00-19 00
31
Serial No. 00-31
within the group
X-XXXXXXXX
NONE
Station No.
No data
NOTE 1: The maximum number of simultaneous calling for single line stations/PSs Stations is 12 per chassis.
When the number of single line stations/PSs Stations exceeds 12, allocate the rest of stations to anoth-
er chassis. For a Multiline Terminal (My Line/Virtual Line), there is no limit as the above.
NOTE 2: Set the second data to the station number set by CM10 when PSs are used.
NOTE 3: Maximum of 32 stations per Group Call can be assigned (However, maximum of 5 PSs can be as-
signed for PSs).
30 Specification of the
My Line number that
displays the calling
number
XX YY XX: Tenant No. 00-63
YY: Allocation No.
00-07
X-XXXXXXXX
NONE
My Line No.
No data
NOTE: The number of stations that can display the calling number on LCD is maximum 8 per tenant. Set the
allocation number to the stations that displays the calling number.
Continued on next page
JANUARY/14/2011
CM57
To Next Page
Loading...
