Y 1ST DATA 2ND DATA
RELATED
COMMAND
No. MEANING DATA MEANING DATA MEANING
00 NOTE 3: The table below shows the default setting of the CODEC List.
* A-law/µ-law depends on CPU or CM04 Y=10-59.
NOTE 4: G.722 (Wide Band Codec) is available only when using DT700 Series (DT730/DT750)/SP350/VoIP-
DB (PZ-64IPLA/PZ-128IPLA)/Standard SIP station.
NOTE 5: Although G.722 (Wide Band Codec) is not available for VoIPDB (PZ-64IPLC-A/PZ-128IPLC-A),
when only G.722 is set on the CODEC list, the CODEC is converted into G.711. However, in this state,
when the opposite office connected via IPT (P2P CCIS) is also set to G.722 only, a call is not available
because there is no available CODEC. Therefore, set this data including the available CODEC
(G.711 or G.729a).
NOTE 6: G.723.1 is not available when using DT700 Series/D
term
IP INASET/D
term
SP30/SP350/MH240/
VoIPDB (IP-PAD/IPT [P2P CCIS])/Standard SIP station.
Continued on next page
To Next Page
Loading...
