NEC Univerge SV8300 - Page 600

3-544 NWA-033623-001 Rev.8.1
91ch3006.fm
COMMAND CODE
TITLE:
MULTILINE TERMINAL KEY ASSIGNMENT
90
YSETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
10 Key setting of program-
mable pattern 1
– Same as CM90 Y=00 CM04 Y=00>02
NOTE: Be sure to set the Key No. “F5099” (My Line) to any key on the Multiline Terminal or the Add-on
Module when programmable pattern 1 is assigned.
JANUARY/14/2011
CM90