NEC Univerge SV8300 - Page 621

3-565 NWA-033623-001 Rev.8.1
91ch3006.fm
COMMAND CODE
TITLE:
MULTILINE TERMINAL SOFT KEY ASSIGNMENT
9A
NOTE 1: When the 2nd data of CM12 Y=23 is set to “3”, the default Soft Key pattern is assigned as
shown on Page 3-568.
NOTE 2: Pattern No. 3 is fixed.
NOTE 3: Help key is only available in Pattern No. 3.
Continued on next page
: Default
Y 1ST DATA 2ND DATA
No. MEANING DATA MEANING DATA MEANING
10
13
Setting of Soft
Key name for
each Pattern
Number (Pattern
Number 0-3)
aa bb aa : Status Number (00-11)
00: Idle State
01: During dialing
(Holding no call)
02: During dialing
(Holding a station/trunk)
03: During calling
(Holding no call)
04: During calling
(Holding a station/trunk)
05: Being called
06: When called party is busy
(Holding no call)
07: When called party is busy
(Holding a station/trunk)
08: When called party sets DND
09: Trunk Busy
10: During Speaking
(Holding no call)
11: During Speaking
(Holding a station/trunk)
bb: Soft Key Number (00-15)
00-03: Indicated on 1st display
04-07: Indicated on 2nd display
08-11: Indicated on 3rd display
12-15: Indicated on 4th display
XX...XXX
NONE
Soft Key name indicated
on LCD (2-12 characters)
See Character Code
Table for English in
CM77.
See Chapter 1, CAT
Key Assignment.
No data
~
JULY/15/2011
CM9A