NEC Univerge SV8300 - Page 634

3-578 NWA-033623-001 Rev.8.1
91ch3007.fm
COMMAND CODE
TITLE:
CCIS CHANNEL/IP TRUNK/SIP TRUNK DATA 2
A8
FUNCTION:
This command is used to assign a destination office for a message to be transferred (e.g. service infor-
mation) and the Common Channel Handler (CCH), IP trunk and SIP trunk which accommodate the mes-
sage.
PRECAUTION:
None
ASSIGNMENT PROCEDURE:
DATA TABLE:
ST
EXE++ +
+
A8Y
2ND DATA
DE
1ST DATA
(5 digits) (2-12 digits)
++
DE
: Default
NOTE 1: A maximum of 256 DPCs per system can be assigned.
NOTE 2: Programming procedure of CMA8 Y=0 is as follows.
- For IPT (P2P CCIS), set this data IPT No. 00.
- For Point-to-Point connection to SIP trunk (CMA7 Y=46: 1), set this data to SIP trunk No.
of SIP trunk that is used for DPC of SIP server assigned by CMA7 Y=02.
- For Point-to-Multipoint connection to SIP trunk (CMA7 Y=46: 0), set this data to SIP
trunk No. of SIP trunk that is used for DPC of SIP server assigned by CM8A Y=5XXX>
168.
Continued on next page
Y
1ST DATA 2ND DATA
RELATED
COMMAND
No. MEANING DATA MEANING
0 00001
16367
NOTE 1
Destination Point Code
(DPC) sent from distant
office assigned by CMA7
Y=02
00
15
NONE
CCH/IP trunk/SIP trunk No. 00
CCH/IP trunk/SIP trunk No. 15
No data NOTE 2
CMA7 Y=02
1 000000000001
255255255254
NONE
IP Address
(Maximum 12 digits)
No data NOTE 3
CMA7 Y=02
~
~
~
~
APRIL/16/2010
CMA8