: Default
Y 1ST DATA 2ND DATA
RELATED
COMMAND
No. MEANING DATA MEANING DATA MEANING
56 Session Timer method 00
31
Profile number
for control packet
0
1
3
UPDATE
INVITE
Auto
CMA7 Y=71
CMBA
Y=29, 83, 88
NOTE 1: When the second data is set to 3, the session timer method is decided by the receiving message from
the communicated terminal.
NOTE 2: Set the second data to “3” for Point-to-Multipoint connection (when CMA7 Y=46 is set to “0”).
70 SIP trunk registration
method to the SIP
server
00
31
Profile number
for control packet
0
3
To register the time
set by CMBA Y=71
Not registered
CMA7 Y=71
CMBA Y=71
NOTE 1: SIP trunk is re-registered half the time set by CMBA Y=71 to SIP server periodically when the sec-
ond data is set to “0”.
NOTE 2: Set the second data to “3” for Point-to-Multipoint connection (when CMA7 Y=46 is set to “0”).
71 Setting of SIP trunk
registration expiry time
to the SIP server
00
31
Profile number
for control packet
120
4294967294
NONE
120 seconds
4294967294 seconds
3600 seconds (1hour)
CMA7 Y=71
CMBA Y=70
NOTE 1: This data setting is effective only when CMBA Y=70 is set to 0.
NOTE 2: Set the time to cancel the registration after registering SIP trunk with this command to SIP server.
NOTE 3: When the registration has been canceled by SIP server, re-register to SIP server for half the period
of time set by this command (in case of 3600 seconds, set 1800 seconds).
NOTE 4: When re-registration from SIP server is not executed during the period of time set by this command
after the registration has been canceled by SIP server, call reception from the network to SIP is
restricted.
NOTE 5: Set the second data to NONE for Point-to-Multipoint connection (when CMA7 Y=46 is set to “0”).
72 Setting of Authentica-
tion user name when
registering to/receiv-
ing from the SIP server
with character code
00
31
Profile number
for control packet
XXX...X
NONE
User name
(Maximum 32 digits)
No data
CMA7 Y=71
CMBA Y=73
NOTE 1: You can also confirm the user name set by CMBA Y=73 with this command.
NOTE 2: Set the second data to NONE for Point-to-Multipoint connection (when CMA7 Y=46 is set to “0”).
Continued on next page
To Next Page
Loading...
