NOTE 1: This data can be set from PCPro connecting to Primary Unit, or Secondary Unit in Failover
mode.
NOTE 2: The case when CMFB Y=20>XX99: 0 is displayed is as follows.
- The specified unit is disconnected.
- The specified unit is downloading the firmware of Access Blade/VoIPDB.
NOTE 3: When executing CMFB Y=20>XX99: 9999, the target unit is started to reset immediately.
Secondary Unit and Remote Unit can be reset from Primary Unit by this data. Remote Unit
can be reset from Secondary Unit in Failover mode by this data. No units can be reset from
Remote Unit by this data.
Y 1ST DATA 2ND DATA
No. MEANING DATA MEANING DATA MEANING
20 Failover Informa-
tion Read
[8300R6]
XX00 Unit operation status
(Display only)
XX: Unit No. (01-50)
NOTE1
00
01
10
11
12
20
21
22
23
NONE
Primary Unit: Disconnect
Primary Unit: Operating normally
Secondary Unit: Disconnect
Secondary Unit: Normal mode
Secondary Unit: Failover mode
Remote Unit: Disconnect
Remote Unit: Normal mode
(Connecting to Primary Unit)
Remote Unit: Normal mode
(Connecting to Secondary Unit)
Remote Unit: Survival mode
No Unit installed
XX01 Connection status with
Primary Unit/Secondary
Unit (Display only)
XX: Unit No. (01-50)
NOTE1
00
01
10
11
Primary Unit: Disconnect
Secondary Unit: Disconnect
Primary Unit: Disconnect
Secondary Unit: Connect
Primary Unit: Connect
Secondary Unit: Disconnect
Primary Unit: Connect
Secondary Unit: Connect
XX99 Unit Reset
XX: Unit No. (02-50)
0
1
Reset unavailable NOTE 2
Reset available
9999 Reset execution NOTE 3
To Next Page
Loading...
