NEC Univerge SV8300 - Page 98

3-42 NWA-033623-001 Rev.8.1
91ch3001.fm
COMMAND CODE
TITLE:
BASIC SERVICES
08
: Default
BASIC SERVICE SETTING DATA
156 Dialing of a Single Digit Feature Access Code while the calling
station hears RBT, or performs a Voice Call
0
1
Available
Not available
The table below shows the available features and its access codes for Single Digit Feature Access Code, while
the calling station hears RBT.
NOTE 1: While the Multiline Terminal or DP telephone is holding the other call, this feature is not available.
NOTE 2: While the DTMF telephone is holding the other call, this feature is not available.
157 Paging answer by PGD(2)-U10 Station Dialing (only in the
case of Delay and Non-delay answer)
NOTE: The Paging Answer by the following methods is
applied depending on the setting of this command.
- When the second data is set to “0”: PGD(2)-U10
station number assigned by CM10 Y=00.
- When the second data is set to “1”: Paging Answer
Zone 0-9 assigned by CM20 Y=0-3: A070-A079.
0
1
Available
Not available
158 All Zone Internal Paging
See CM56 Y=00-07 CM20 Y=0-3: A164
0
1
Not available
Available
161 Transfer a trunk line placed in Consultation Hold by Trunk-
Direct Appearances (Hold Transfer)
0
1
Available (Hold Transfer)
Not available (Consultation Hold)
162 Multiple Radio Paging access after accessing a Radio Paging
trunk with delay type Radio Paging
NOTE: This is ineffective when CM08>157: 0.
0
1
Not available
Available
Continued on next page
Access
Code
Service
Calling Station Kind
Attendant
Console
Multiline
Terminal
DP
Telephone
DTMF Telephone
1 Voice Call Available Available Available Available after Hooking
NOTE 2
2 Call Back-No Answer Not
Available
Available
NOTE 1
Available
NOTE 1
Available after Hooking
NOTE 2
6 Message Reminder/
Message Waiting Set
Available Available Available Available after Hooking
NOTE 2
8 Message Waiting
Record
Available Available Available Available after Hooking
NOTE 2
JANUARY/14/2011
CM08