: Default
BASIC SERVICE SETTING DATA
163 Step Call for an incoming call from a Tie Line 0
1
Not available
Available
165 Replay timer for Attendant Delay Announcement
[8300R2]
0
1
Replay at an interval
See CM41 Y=0>47
Replay only once
168 When the Multiline Terminal station dials “#” during setting of
Station Speed Dialing
0
1
“#” is set as paused data (1.5 seconds)
“#” is set as dialed digit
171 When the Multiline Terminal station dials “*” during setting of
Station Speed Dialing
0
1
“*” is set as programmable pause by
CM41 Y=0>38
“*” is set as dialed digit
172 Automatic Idle Return on Multiline Terminal 0
1
Not available
Available
176 1000-Slot Memory Block number “02” for Station Speed Dial-
ing is used as the Memory Block for System Speed Dialing
0
1
Available
See CM20 Y=0-3: A068
Not available
177 Last Number Call (Last Number Redial for Single Line Tele-
phone)
0
1
Available
See CM20 Y=0-3: A069
Not available
179 Ringing cadence on Direct in Termination
[Other than North America]
0
1
As per CM35 Y=033
Special Ringing for Multiline Termi-
nal See CM08>397
As per CM04 Y=00>07 for Single
Line Telephone
Ringing cadence on Direct in Termination
[North America Only]
0
1
As per CM35 Y=033
Special Ringing for Multiline Termi-
nal
0.25 seconds ON-0.125 seconds OFF
-0.25 seconds ON-0.125 seconds OFF
-0.25 seconds ON-2 seconds OFF
As per CM04 Y=00>07 for Single
Line Telephone
Continued on next page
To Next Page
Loading...
