Newport 1936-R series - Pm:run; Pm:satlevel

Communication Command Reference 105 105
8.3.3.69 PM:RUN
Description Run command
Syntax PM:RUN mode
Remarks The PM:RUN command disables or enables the acquisition of data.
Argument Value Description
Mode 0 Stop
1 Run
Related Commands: PM:RUN?, PM:MODE?
8.3.3.70 PM:RUN?
Description Run query
Syntax PM:RUN?
Remarks The PM:RUN? query returns an integer indicating the
present run mode.
Response Value Description
Mode 0 Stopped
1 Running
Related Commands: PM:RUN, PM:MODE?
8.3.3.71 PM:SATLEVEL
Description Set detector saturation current density or power level
Syntax PM:SATLEVEL value
Remarks This command sets or overrides the saturation density value
recorded in the detector calibration
Argument Type Description
Value float saturation current density ( A/cm² ) for
semiconductor detector or saturation power
( W ) for thermopile detector.
Related Commands: PM:SPOTSIZE, PM:SATLEVEL?
8.3.3.72 PM:SATLEVEL?
Description Query detector saturation current density or power level
Syntax PM:SATLEVEL?
Remarks This command query the saturation density value which is
set by PM:SATLEVEL command