3 System Overview
3.1 Startup Procedure
Provided that the power meter has been installed in an appropriate
environment and its power cord is connected to a working electrical outlet,
power-up the power meter by pressing the power button on the lower left
corner of the front panel.
For precise accuracy, 1936/2936 Series power meters should be allowed to
warm up for one hour before being used for measurements.
3.2 Front Panel Layout
The front panel layout is the same for both the 1936 and 2936 products.
Figure 15 Front Panel Layout
WARNING
To avoid electrical shock hazard, connect the instrument to
properly earth-grounded, 3-prong receptacles only. Failure to
observe this precaution can result in severe injury.
To Next Page
Loading...
Need help?
General
