13 Appendix C - Legacy
Commands Reference
Sets the backlight level of the display and the keypad
Returns the backlight level of the display and the keypad
Switches to the n - screen display.
Returns displayed screen number, 0 – n/a screen
number, 1 – Main, etc.
Sets the analog output range to the desired level
Returns the analog output range
Selects if the attenuator's calibration data is included for
power calculation.
Returns setting if attenuator data should or should not be
used when calibrating the power meter.
Gets the attenuator serial number.
Sets the power meter ranging to manual or automatic.
Returns 1 if automatic power meter ranging is selected.
Returns the calibration date of the detector.
Returns the temperature at which the calibration was
performed.
Selects the power meter channel to display and control.
Returns the power meter channel currently selected.
Returns the model number of the detector.
Returns the serial number of the detector.
Set data store behavior select.
Return data store behavior select.
Return data store count of items stored.
Return data store enable.
Return data store data. {1,1-10,-5,+5} – value, range,
oldest 5, newest 5
Sets the size of the Data Store buffer
Return the sizes of the Data Store buffer
Return data store interval.
Saves the data store buffer to USB flash disk
Return data store max size.
Selects the filtering operation: no filtering, analog filter,
digital filter, or analog and digital.
Returns the filtering operation: no filtering, analog
filter, digital filter, or analog and digital.
Sets the wavelength for use when calculating power.
Gets the selected wavelength in nanometers.
To Next Page
Loading...
