Newport 1936-R series - Pm:temp; Pm:temppoll; Pm:therm:predict

108 Communication Command Reference
8.3.3.80 PM:Temp?
Description 918 detectors temperature query
Syntax PM:Temp?
Remarks The PM:Temp? query returns the 918 detector's
temperature as a float in degrees Celsius.
Response Type Description
temp float Detector temperature in degrees Celsius (°C)
Related Commands: PM:ATT?
8.3.3.81 PM:Temppoll
Description Enable temperature polling of 918D detectors
Syntax PM:Temppoll enable
Remarks The PM:Temppoll enables or disables the periodic
measurement of the 918D temperature sensor.
Argument Value Description
enable 0 Disabled
1 Enabled
Note: The default startup state of the 1936-R / 2936-R is that temperature
polling is enabled.
Related Commands: PM:Temppoll?
8.3.3.82 PM:Temppoll?
Description Queries the state of the 918D temperature
Syntax PM:Temppoll?
Remarks The PM:Temppoll? query returns the status of the 918D
temperature measurement.
Argument Type Description
enable int See PM:DS:Enable for a description of the
enable argument
8.3.3.83 PM:THERM:PREDICT
Description Thermopile prediction command
Syntax PM:THERM:PREDICT mode