Newport 1936-R series - Pm:therm:predict; Pm:trig:external

Communication Command Reference 109 109
Remarks The PM:THERM:PREDICT command disables or enables the
thermopile prediction algorithm. When this algorithm is enabled,
the instrument predicts the power measured by thermopile
detector very accurately, a few seconds faster than the natural
response of the detector.
Argument Value Description
Mode 0 Disable prediction algorithm
1 Enable prediction algorithm
Related Commands: PM:THERM:PREDICT?
8.3.3.84 PM:THERM:PREDICT?
Description Thermopile prediction query
Syntax PM:THERM:PREDICT?
Remarks The PM:THERM:PREDICT? query returns the state of
thermopile prediction algorithm.
Response Value Description
Mode 0 Prediction algorithm is disabled
1 Prediction algorithm is enabled
Related Commands: PM:THERM:PREDICT
8.3.3.85 PM:TRIG:EXTernal
Description External Trigger Enable
Syntax PM:TRIG:EXTernal <enable>
Parameters
The parameter <state>is either 0, 1, 2, or 3. If <state>is 0 then the external
trigger is disabled. If <state>is 1 then the external trigger is enabled on
channel A. If <state>is 2 then the external trigger is enabled on channel B. If
<state>is 3 then the external trigger is enabled on both channels.
Function
This command enables or disables the external trigger input on the back
panel.
Related Commands: PM:TRIG:EXTernal?
8.3.3.86 PM:TRIG:EXTernal?
Description External Trigger Enable Query
Syntax PM:TRIG:EXTernal?
Parameters None