General Information 31
WARNING
Do not attempt to operate this equipment if there is evidence of
shipping damage or you suspect the unit is damaged. Damaged
equipment may present additional hazards to you. Contact
Newport technical support for advice before attempting to plug
in and operate damaged equipment.
2.9 Available Options and Accessories
Newport Corporation also supplies temperature controlled mounts, lenses,
and other accessories. Please consult with your representative for additional
information.
2.10 Parts List
The following is a list of parts included with the 1936/2936 Series Optical
Power Meters:
User’s Manual (Hardcopy or CD)
Software Drivers and Utilities (CD)
Power cord
Two fuses
If you are missing any hardware or have questions about the hardware you
have received, please contact Newport Corporation.
2.11 Choosing and Preparing a Suitable Work Surface
The Models 1936/2936 Series Optical Power Meters may be placed on any
reasonably firm table or bench during operation. The front legs of the unit
can be pulled out to tilt the unit at an angle, if desired.
Provide adequate distance between the 1936/2936 Series Optical Power
Meters and adjacent walls for ventilation purposes. Approximately 2-inch
spacing for all surfaces is adequate.
2.12 Electrical Requirements
Before attempting to power up the unit for the first time, the following
precautions must be followed:
WARNING
To avoid electric shock, connect the instrument to properly
earth-grounded, 3-prong receptacles only. Failure to observe
this precaution can result in severe injury.
Have a qualified electrician verify the wall socket that will be used is
properly polarized and properly grounded.
To Next Page
Loading...
Need help?
General
