4
02. SPECIFICATIONS
POWER SUPPLY
External 12VDC 2A power supply, not included, equipped with lter for tran-
sient from mains input (AC) and output (DC).
OPERATION TYPE
Operates interconnected to the new RTX3004, CTW3004 and RMF3004
receivers maintaining compatibility with the Linear-HCS line TX-4A, CTW-
-4A, CTWB, Multifunction and Multifunction 4A. Through the receivers it is
possible to restrict the access of a given device to specic locations through
the CAN addresses 1-8 congured in the receivers. It allows connection
with the 7-Key Terminal Block Module (via Adapter Interface, on request),
also used to send alerts to monitoring/alarm centers and the like (via the
dry relay contact).
CONNECTIONS:
- One USB Host input for ash drive connection (for rmware
update, complete backup of equipment data), USB scanner (for device re-
gistration) and computer keyboard (to facilitate the insertion of user data
during programming).
- One RS232 communication port for computer interface.
- One TCP/IP communication port for computer interface
(network communication).
- One input for Wiegand 26 or 34-bit scanners or external RS485
to facilitate the registration of biometrics, cards and proximity keyfobs.
- One RS485 input for communication with adapter interface for
7-key terminal block module (on request).
- Two independent CAN ports for communication with Linear-H-
CS receivers or controller boards.
CONNECTION WITH RECEPTORS
Connection between MG3000 and Receivers via CAN Network. Baud rate
(Br)/Cable Size (m)
Br. 125kbps/500m Br. 20 kbps/1000 m
NOTE: AFT 2X22 AWG cable is recommended.
SUPPORTED DEVICES
- Remote Controls NICE Era One, Era Inti (compatible with Linear-HCS
controls);
- Proximity cards and 125kHz keyfobs or Mifare 13.56MHz NICE
and Linear-HCS;
- Active NICE and Linear-HCS tags;
• Interconnection with Linear-HCS Water Shortage Alarm.
- ENGLISH -
207
To Next Page
Loading...
Need help?
General
