Nice MG3000

82
11.11.1 HOW TO CONFIGURE A GROUP
Door sensor delay Biometric Controller open door alarm
time in seconds [0 to 250]
Schedule bell delay Programmable alarm time in seconds
[0 to 15]
Clock calibration Time in seconds for clock o󰀨set [-60 to
+60]
Dry nger Wet nger adjustment [0 to 8]
Remove nger 2nd Awaits the nger removal from the sen-
sor
If the receiver or scanner is not present or does not respond to the reading re-
quest sent by the MG3000, after 3 seconds the module will return the message
“NO ANSWER”.
NOTE: The use of “GROUPS” is only valid when the MG3000 is used with
RMF3004 receivers or 4A Multifunction Receivers.
Through the option “GROUPS” it is possible to select user groups and dene
dates and times for each group to have access granted.
This conguration can be useful for controlling the access of employees or ser-
vice providers who do not have free access to the building, increasing security
and preventing users from having access outside the allowed days and times.
Figure 11.10.d
11.11 GROUPS
Access the option “GROUPS” and enter the identication name for group 1.
Then tap “RECORD” and tap “PROCEED”.
- ENGLISH -
285