87
When you have two modules working on the same CAN network, in order for
the events to be displayed correctly in both of them, it is necessary to perform
a synchronization by means of a ash drive. To perform the operation, proceed
as follows:
- Choose one of the devices to manually save the settings and/or
devices that will later be copied to the other MG3000 (we will call this device
“Master” and the secondary one “Slave”).
- Perform the settings and save them. In the case of recording new
devices, register and update the receivers normally before starting the procedu-
re. After the process in the “Master” MG3000 is nished, insert the ash drive
in it, access the programming menu (“BASIC MENU”), and select “BACKUP”
[Figure 12.a]. Make the backup on the ash drive and wait until the backup conr-
mation message is displayed [Figure 12.b]. Press “BACK” to complete the action
and remove the ash drive.
12. SYNCHRONIZATION OF TWO MODULES IN THE
SAME CAN NETWORK
Figure 12.a
Figure 12.b
- Insert the ash drive in the “Slave” MG3000, access the “RESTORE” option
in the “ADVANCED MENU” [Figure 12.c], select the corresponding backup le,
identifying it by the label that was recorded with the “Master” MG3000 time, date
and SUPPORT labels at the time of backup [Figure 12.d]. Perform data resto-
ration, tap the “HOME” button, press the “NO” key, and remove the ash drive
[Figure 12.e]. After performing this procedure, the events generated by the acti-
vation of registered devices must appear in the two modules.
- ENGLISH -
290
To Next Page
Loading...
Need help?
General
