47
It is important to note that changes in the text of any labels must be preceded
by pressing the “SAVE” key so that this text is eectively saved in the MG3000’s
internal memory. If the operator makes the change and press “BACK”, “HOME”
or “PROCEED” the change in the text will not be registered.
The “HOUSING” option allows the denition of the labels to be displayed during
the operation. In this function, there are two checkboxes where it is possible to
choose the form of parameters that best ts the installation site. The settable op-
tions are: Apartment, Access, Unit, Room, Court, Lot, House, Block and “Label”
(“Label” option is only available for the label selection box for the block eld).
During the normal operation of the equipment, when activating a registered de-
vice, events containing these labels will be shown on the MG3000’s display.
To change the settings, access the option “HOUSING”. Once the selection is
made, it is recorded and will be presented during the events and the registration
procedure.
Figure 11.2.1.a
Figure 11.2.1.b
11.2.1 LABELS - HOUSING
- ENGLISH -
250
To Next Page
Loading...
