Nikon VBA23001 - SB;IF PCB Unit

VBA23001-R.3762.A
- A43 ･ D90 -
・Mount the SB/IF PCB unit (#B1041) by fitting with the bosses.Mount the SB/IF PCB unit (#B1041) by fitting with the bosses.
(The FPC must be placed over the coil as below.) (The FPC must be placed over the coil as below.))
・Tighten the two screws (#612).Tighten the two screws (#612).
・Solder the wires (Red/Black/Orange).Solder the wires (Red/Black/Orange).
Coil
SB/IF PCB unit
Screw (#612)
×
2
Wire
×
3 (Red/Black/Orange)
・Attach the gasket (#77, #83, and #473) along the outside rim of each connector.gasket (#77, #83, and #473) along the outside rim of each connector.
(#77)
(#83)
(#473)
INC