・Attach the grip red mold (#29) to grip rubber unit (#B26).Attach the grip red mold (#29) to grip rubber unit (#B26).
・Attach the spring (#161) from behind, and tighten the screw (#638).Attach the spring (#161) from behind, and tighten the screw (#638).
・Attach the button (#390) and the conducting rubber (#389).Attach the button (#390) and the conducting rubber (#389).
・Attach the plate (#388).Attach the plate (#388).
・Adhere the tape (#811).Adhere the tape (#811).
・Adhere the tape [TA0005 (3.3 × 11)].Adhere the tape [TA0005 (3.3 × 11)].
・Mount the grip rubber unit (#B26).Mount the grip rubber unit (#B26).
・Tighten the screws (#627 and #618).Tighten the screws (#627 and #618).
Grip rubber unit (#B26)
Grip rubber (#26)
Grip red mold (#29)
Spring (#161)
Screw (#638)
Button (#390)
Conducting rubber (#389)
Plate (#388)
Tape [TA0005 (3.3
×11
)]
Tape (#811)
Grip rubber unit
Screw (#627)
Battery chamber
Screw (#618)
VBA23001-R.3762.A
- A73 ･ D90 -
A70
Changed page △×１
△（Revision）
October. 2. 2008
To Next Page
Loading...
