VBA23001-R.3762 .A
- D1 ･ D90 -
Caution:
① In disassembly/(re)assembly, be sure to use conductive mat (J5033) and wrist strap (J5033-5), in
order to protect electric parts from static electricity.
② Before disassembling, be sure to remove batteries or AC power cord.
③ In disassembling, be sure to memorize the processing state of wires and FPC, screws to be xed and
their types, etc.
④ The low-pass lter of the image PCB/base plate is easily damaged. Handle it very carefully.
Points to notice for Disassembly and Assembly
WARNING
There are high voltege parts inside. Be careful of this electric shock,
when you remove the cover.
You must discharge the main condenser according to the instruction
of this repair manual after you remove the cover.
!
Caution:
When "Separation of Front body from Rear body", "Disassembly of Image sensor unit"
and "Disassembly of Bayonet" are performed, be sure to carry out "RESET AF-DEFOCUS
COMPENSATION" of the D90 adjustment software after assembly.
Points to notice for Lead-free solder products
・ Lead-free solder is used for this product.
・ For soldering work, the special solder and soldering iron are required.
・ Do NOT mix up lead-free solder with traditional solder.
To Next Page
Loading...
