Nikon VBA23001 - F-Min SW; Release Button

VBA23001-R.3762.A
- A5 ･ D90 -
・Solder the wires (Black/Red).Solder the wires (Black/Red).
・Mount the F-min SW B (#134) by fitting with bosses of the F-min SW unit (#B133).Mount the F-min SW B (#134) by fitting with bosses of the F-min SW unit (#B133).
(The contact brush of [#134] must be placed on inside of [#B133] as below.) (The contact brush of [#134] must be placed on inside of [#B133] as below.)The contact brush of [#134] must be placed on inside of [#B133] as below.)[#134] must be placed on inside of [#B133] as below.)must be placed on inside of [#B133] as below.)#B133] as below.)
・Tighten the screw (#642).Tighten the screw (#642).
F-min SW unit (#B133)
Wire
×
2 (Black/Red)
Screw (#642)
F-min SW
Release buttonRelease button
・Mount the A/M change cam (#122).Mount the A/M change cam (#122).
A/M change cam (#122)
・Attach the release button holder (#B116).Attach the release button holder (#B116).
Release button holder (#B116)
F-min SW B (#134)
Grease: LEN317A
INC