Nikon VBA23001 - Separation of Front Body from Rear Body; Eyepiece Mold

VBA23001-R.3762 .A
- D40 ･ D90 -
4. Separation of Front body from Rear body
Solder bridges
Wire
×
2 (Black/Red) of SQ motor
Wire
×
2 (Black/Gray) of the mount GND
Wire
×
2 (Black) of the buzzer unit
・Remove the solder bridge at two places on the power drive PCB (#B1002).Remove the solder bridge at two places on the power drive PCB (#B1002).
・Unsolder the wires (Black/Gray) of the mount GND.Unsolder the wires (Black/Gray) of the mount GND.
・Unsolder the wires (Black/Red) of the SQ motor.Unsolder the wires (Black/Red) of the SQ motor.
・Unsolder the wires (Black) of the buzzer unit.Unsolder the wires (Black) of the buzzer unit.
Eyepiece mold
・Take out the two screws (#615).Take out the two screws (#615).
・Remove the sponge (#752), the eyepiece mold (#291), and the sponge (#779).Remove the sponge (#752), the eyepiece mold (#291), and the sponge (#779).
Screw (#615) × 2
Sponge (#752)
Eyepiece mold (#291)
Sponge (#779)
INC