VBA23001-R.3762.A
- A110 ･ D90 -
＜
Measurement of Consumption current value
＞
When this camera is used for measuring the consumption current value, connect the battery tool (J61213), and
turn the change-SW to OFF. Then make measurements based on the following.
＋
＋
－
－
7.8V 0.3Ω
Test item Standard Test condition
Main SW /
OFF
All operational buttons are NOT pushed. ref. above.
AF50/1.4D
、
EV12
Main SW /
ON (Half-release timer OFF)
Main SW /
ON (Half-release timer ON)
Main SW /
ON (Illumination ON)
Main SW /
ON (TFT ON)
Main SW / ON (Operating consumption current)
《
Inspection standards
》
Turn change-SW to OFF.
Caution:
When the consumption current value is measured, backup battery must be fully charged.
Ａ
400mA or less
200mA or less
250μA or less
250μA or less
250mA or less
4A or less
To Next Page
Loading...
