- 65 -
Table of Setting Items in the Control Panel Menu Screen
Print Setup
z
Shaded areas are factory-set values.
Item Value Description
Personality Auto
PCL
PostScript
Select the print language. Print language switching
is automatic when set to [Auto].
Copies 1
～
9999
Sets the copy quantity.
This setting is ignored in case of local print.
This setting is disabled unless the [Job Copy]
setting is 1.
Job Copy 1
～
999
Sets the print quantity.
This setting is ignored in case of local print.
The settings in the printer driver always overwrite
these settings.
* This setting is enabled only if [Collate] is checked
and 1 is specified as the number of copies in the
PCL printer driver.
Edge to Edge On
Off
Sets the print margin.
Resolution 600dpi
1200dpi
Sets the resolution.
Toner Save Toner Save Level Off
Low
Middle
High
Set the toner save quantity.
Specifies [Off] when toner save mode is disabled.
Color All
Except 100%
Black
All:
All colors, including 100% black, comprise all the
target colors for toner saving.
Except 100% Black:
All colors, excluding 100% black, comprise all the
target colors for toner saving.
Check Unnecessary Print Cartridge On
Off
Set whether to generate an error or continue
printing when a print cartridge is detected to
be down even though it is not being used as a
specified color for the print data.
On:
An error is displayed and the print job is
cancelled, to give priority to the service life of
the print cartridge.
Off:
A warning screen is displayed, but printing
continues because priority is given to
productivity.
Default Orientation Portrait
Landscape
Sets the print orientation.
Trapping Off
Narrow
Narrow /
Choke White
Wide
Wide / Choke
White
Choke White
Sets trapping.
[Narrow/Choke White], [Wide/Choke White], and
[Choke White] are displayed for the Pro1050 only.
To Next Page
Loading...
