Olivetti PR2 plus - Page 62

4-8 Service Manual
XZAC4219-05
If the «INTERFACE» parameter has been configured as SERIAL1
Parameter Values possible Description
RS1 EMULATION
OLIVETTI *
Default emulation of the port.
IBM
BAUD RATE
9600 *
Data transmission/reception speed.
4800
2400
1200
19200
38400
BIT/CHAR
7
Data format at 7 or 8 bits.
8 *
PARITY
NONE *
This parameter is used to set the presence and type of
parity control (even or odd). By default, parity control is
disabled (none).
ODD
EVEN
STOP BIT
1 *
Number of stop bits.
2
DSR
N
Data Set Ready managed or not
Y *
DCD
NO *
Data Carrier Detector managed or not.
YES
If the «INTERFACE» parameter has been configured as PARALLEL
Parameter Values possible Description
PAR. EMULATION
OLIVETTI *
This parameter is used to set the emulation type of the
parallel port.
IBM
PAR. PORT MODE
CX
This parameter is used to set the operation mode for
the parallel port.
BIDIRECT.