G-29
Appendices
MicroHAWK V320-F / V330-F / V420-F / V430-F Barcode Reader User Manual
G-18 Composite
G
G-18-1 Separator Status (Composite)
G-18 Composite
When set to Enabled or Required, will decode the 2D composite component of a linear symbol. The
linear symbol can be DataBar-14, DataBar Expanded, DataBar Limited, EAN-128, UPC-A, EAN-13,
EAN-8, and UPC-E.
If Composite is set to Enabled, the reader will decode both the 2D composite and linear components.
However, if the 2D composite component is not decoded, the linear data will be sent by itself at the end
of the read cycle.
If set to Required, the reader must decode both components, or a No-Read will occur.
•
Note:
The Separator Character will be the same as the character defined in the
Multisymbol Separator
field of the
<K222> command.
Usage: Allows reading by both linear and 2D readers.
Definition: Combines 2D and linear width-modulated symbology on the same symbol
where different messages can be read by each reader type.
Serial Cmd: <K453,mode,separator status,separator>
Default: Disabled
Options: 0 = Disabled 1 = Enabled 2 = Required
Enabled
Required
G-18-1 Separator Status (Composite)
Usage: Allows the user to distinguish between the main and Supplemental symbols.
Definition: Separates the linear and the composite component.
Serial Cmd: <K453,mode,separator status,separator>
Default: Disabled
Options: 0 = Disabled 1 = Enabled
G-18-2 Separator Character (Composite)
Usage: As required by the application.
Definition: Allows the user to change the separator character from a comma to a new
character.
Serial Cmd: <K453,mode,separator status,separator>
Default: , (comma)
Options: Any ASCII character.
To Next Page
Loading...
Need help?
General
