Omron MicroHAWK V320-F - Load Current Settings from Configuration Database

Appendices
L-14
MicroHAWK V320-F / V330-F / V420-F / V430-F Barcode Reader User Manual
L-7 Load Current Settings from
Configuration Database
Example:
<K255-,5>
This command phrase loads the configuration settings contained in database index 5 to current, active
configuration settings.
• The current DataBar Expanded status does not change if it is configured as Enabled (Stacked) and
the database DataBar Expanded status is Enabled.
• The current DataBar-14 status does not change if it is configured as Enabled (Stacked) and the data-
base DataBar Expanded status is Enabled.
•
Data Matrix ECC level is determined by the current settings and not by database settings . Therefore,
the database does not know which ECC level to enable,
and has no effect on current Data Matrix ECC
settings
.
Definition: Allows the configuration settings contained in a selected database index to
be loaded to current, active configuration settings.
Serial Cmd: <K255-,index>
Notes on Symbol Type