Omron MicroHAWK V320-F - Dotcode

Appendices
G-30
MicroHAWK V320-F / V330-F / V420-F / V430-F Barcode Reader User Manual
G-19 DotCode
• Important: When DotCode is enabled, no other symbologies will be decodable. You must disable DotCode to decode
symbols of any other type.
The reader will not attempt to decode DotCode symbols.
The reader will attempt to decode DotCode symbols.
The reader will decode horizontal and vertical symbols (+/– approximately 3 degrees).
The reader will decode +/– approximately 10 degrees from the horizontal or vertical symbols. It is
slightly slower than the No Rotation option.
The reader will support 360 degree reading. Omnidirectional is significantly slower than the other two
options.
G-19-1 DotCode Status
Serial Cmd: <K497,status,rotation mode>
Default: 0 = Disabled
Options: 0 = Disabled
1 = Enabled
Disabled
Enabled
G-19-2 Rotation Mode
Serial Cmd: <K497,status,rotation mode>
Default: 0 = No Rotation
Options: 0 = No Rotation
1 = Low Rotation
2 = Omnidirectional
No Rotation
Low Rotation
OmniDirectional