Appendices
H-44
MicroHAWK V320-F / V330-F / V420-F / V430-F Barcode Reader User Manual
H-19 Time Since Reset
• Note: Time Since Reset is a read-only command.
Hours uses a 16-bit counter that increments every 60 minutes.
Minutes uses a 16-bit counter that increments every 60 seconds.
•Note: Time counts are reset at power-on, but not with an <A> or <Z> command.
Hours
Serial Cmd: <
K407,hours
,minutes>
Default: 16-bit counter (0 to 65535)
Minutes
Serial Cmd: <
K407,
hours,
minutes
>
Default: 16-bit counter (0 to 60)
To Next Page
Loading...
