Omron MicroHAWK V320-F - Page 456

M-1
MicroHAWK V320-F / V330-F / V420-F / V430-F Barcode Reader User Manual
M
Utility commands are generally commands that are performed during reader operations
to check or determine read rates, or to perform miscellaneous operations on reader
hardware. Serial utility commands are not prefaced with a “K” and a numeric code, nor
do they require an initialization command (<A> and <Z>). They can be entered from
within any terminal program or from WebLink’s Terminal window.
M-1 Operational Commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . M-2
M-2 Read Rate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . M-4
M-3 Counters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . M-5
M-4 Device Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . M-6
M-5 Master Database . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . M-7
M-6 Firmware . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . M-9
M-7 Default/Reset/Save . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . M-10
M-8 Reader Status Request . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . M-12
M-9 Other Operational Serial Commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . M-14
Utilities