Panasonic KX-UT123

Flash Hook Event
Description Specifies the type of signal sent when sending a flash hook event.
Value Range
• Signal
• flashhook
Default Value Signal
Configuration File Reference FLASHHOOK_CONTENT_TYPE (Page 245)
Direct Call Pickup
Description Specifies the feature number assigned to a BLF for performing call
pickup.
Value Range Max. 4 characters (consisting of 0–9, *, and #)
Default Value Not stored.
Configuration File Reference NUM_PLAN_PICKUP_DIRECT (Page 208)
4.6.1.2 Call Rejection Phone Numbers
1–30
Description Specifies the phone numbers to reject incoming calls from. A maximum
of 30 phone numbers can be specified.
Note
• You can also configure this setting through the phone user
interface. If
these settings are changed through the phone user
interface while being changed through the Web user interface,
the settings made through the phone user interface will be
overwritten by the settings made through the Web user
interface.
Value Range Max. 32 characters
Note
• Even if
you specify nonconsecutive fields (e.g., fields 1, 5, and
30), they will be rearranged into consecutive fields after you
save the settings (i.e., 1, 2, and 3).
• If the phone number contains characters other than 0–9, *, #,
and +, the number may not be rejected correctly.
Default Value Not stored.
4.6.2 Call Control [Line 1]–[Line x]
This screen allows you to configure various call features that are specific to each line. The number of lines
available varies depending on the phone being used, as follows:
• KX-UT113/KX-UT123: 1–2
126 Administrator Guide Document Version 2013-03
4.6.2 Call Control [Line 1]–[Line x]