NOM_DELAY_n
Parameter Name Example NOM_DELAY_1, NOM_DELAY_2, …, NOM_DELAY_6
Value Format Integer
Description Specifies the initial delay, in 10-millisecond units, of the jitter buffer.
Value Range
1–7 (´ 10 ms)
Note
• This setting is subject to the following conditions:
– This value must be greater than or equal to "
MIN_DELAY"
– This value must be less than "MAX_DELAY"
Default Value 2
Web User Interface Reference Initial Delay (Page 119)
RTP_PORT_MIN
Value Format Integer
Description Specifies the lowest port number that the unit will use for RTP packets.
Note
• If port numbers are specified in [Channel 1–25] in
4.3.6.3 External RTP Port in the Web user interface, this
setting is ignored and the corresponding external RTP port is
enabled.
Value Range 1024–48750 (even number only)
Note
• The value for this setting must be less than or equal to
"RTP_PORT_MAX" - 400.
• Changing this setting may affect the number of simultaneous
calls
that can be made. Therefore, when setting this parameter,
be aware that the maximum number of necessary ports can be
calculated as shown below:
No. of lines ´ No. of channels ´ 2 ´ 10 (No. of terminals)
Default Value 16000
Web User Interface Reference Minimum RTP Port Number (Page 115)
RTP_PORT_MAX
Value Format Integer
Document Version 2013-03 Administrator Guide 237
5.6.2 RTP Settings
To Next Page
Loading...
