Phone User Interface
Reference
Configuring the Network Settings of the Unit (Page 19)
Configuration File Reference USER_DNS1_ADDR (Page 194)
DNS2
Description Specifies the IP address of the secondary DNS server.
Note
• This setting is available only when [Connection Mode] is set
to [Static].
Value Range Max. 15 characters ("n.n.n.n" [n=0–255], except "0.0.0.0",
"255.255.255.255", "127.0.0.1", etc.)
Default Value Not stored.
Phone User Interface
Reference
Configuring the Network Settings of the Unit (Page
19)
Configuration File Reference USER_DNS2_ADDR (Page 194)
4.3.2 Ethernet Port Settings
This screen allows you to change the connection mode of the Ethernet ports and the VLAN settings.
Note
• When you
change the settings on this screen and click [Save], after the message "Complete" has been
displayed, the unit will restart automatically with the new settings applied. If a unit is on a call when
"Complete" has been displayed, the unit will restart after the unit returns to idle.
• Incorrect settings may cause a network failure. In such a case, you cannot access the Web user
interface anymore. To access it again, you need to correct the speed/duplex settings or perform IP
Document Version 2013-03 Administrator Guide 81
4.3.2 Ethernet Port Settings
To Next Page
Loading...
