Panasonic KX-UT123

• If you select "DHCP" for the connection mode, all the settings concerning static connection will be
ignored, even if they have been specified.
• If you select "DHCP" for the connection mode and "Automatic" for DNS, the DNS server settings
(DNS1 and DNS2) will be ignored, even if they have been specified.
1.1.4 Overview of Programming
There are 3 types of programming, as shown in the table below:
Programming
Type
Description References
Phone user
interface
programming
Configuring the unit’s settings directly from the unit.
®
1.1.5 Phone User Interface
Programming
®
Section 3 Phone User
Interface Programming
Web user
interface
programming
Configuring the unit’s settings by accessing the Web
user interface from a PC connected to the same
network.
® 1.1.6 Web User Interface
Programming
® Section 4 Web User
Interface Programming
Configuration file
programming
Configuring the unit’s
settings
beforehand by creating
configuration files (pre-provisioning), and having the
unit download the files from a server on the Internet
and configure its own settings (provisioning).
® Section 2 General
Information on Provisioning
® Section 5 Configuration
File Programming
1.1.5 Phone User Interface Programming
You can change the settings directly from the unit.
For details about the operations, refer to the Operating Instructions on the Panasonic Web site (® see
Introduction).
For details about additional features available with direct commands, see Section 3 Phone User Interface
Programming.
1.1.5.1
Changing the Language for Phone User Interface Programming
You can change the language used on the LCD. Because the language settings for the LCD of the unit are
not synchronized, you must set the languages individually for the unit.
For details about changing the setting, refer to the Operating Instructions on the Panasonic Web site (® see
Introduction).
20 Administrator Guide Document Version 2013-03
1.1.5 Phone User Interface Programming