Chapter 9
16-bit Timer
IGBT Output with Dead Time IX - 63
TM7BC starts counting up from "0x0000". The IGBT output waveform is "High" until the TM7BC matches the
setting value of TM7OC2. The IGBT output waveform changes to "Low" at the TM7OC2 compare match.
The TM7BC continues counting up. The IGBT output waveform returns to "High" when the binary counter is
cleared by the TM7OC1 compare match.
The IGBT output waveform with dead time is output from the TM7IO pin.
The inverted IGBT output waveform with dead time is output from the TM8IO pin.
13 Set the timer mode register TM7MD3.T7IGBTEN = 1
TM7MD2.TM7PWM = 1
TM8MD3.TM8SEL = 1
TM7MD1.TM7CL = 0
Enable the IGBT output.
14 Select the IGBT output pin TMIOEN1.TM7OEN = 1
TMIOEN1.TM8OEN = 1
P0DIR.P0DIR4 = 1
P5DIR.P5DIR7 = 1
Select the IGBT output pin.
[Chapter 7 I/O Port]
15 Enable the timer counter TM7MD1.TM7EN = 1 Enable the timer count operation.
Step Setting Register Description
To Next Page
Loading...
