Chapter 4
Clock/ Mode/ Voltage Control
Mode/Voltage/Clock Transition IV - 31
4.4 Mode/Voltage/Clock Transition
The following Table:4.4.1 shows the state transition by changing the operation mode, VDD18 voltage and clock.
The mode name in Table:4.4.1 is described in accordance with a rule below.
[Operation mode]_[VDD18 voltage]_[SYSCLK]_[Oscillating clock except SYSCLK]_[Special mode]
[SYSCLK] is described in NORMAL, SLOW, IDLE, HALT0 or HALT1 mode.
[Oscillating clock except SYSCLK] or [Special mode] that corresponded to each condition is described.
For example,
NORMAL_18_HCLK_SCLK
NORMAL mode, VDD18 = 1.8 V, SYSCLK = HCLK (HOSC/HRC), SCLK (SOSC/SRC) = Oscillating
HALT2_11_SCLK_DEEP
HALT2 mode, VDD18 = 1.1 V, SYSCLK = Stop, SCLK (SOSC/SRC) = Oscillating, Deep STANDBY
..
The blanks in Table:4.4.1 mean the mode which setting is prohibited or cannot change.
..
To Next Page
Loading...
