Panasonic MN101L Series

Chapter 13
Serial Interface
XIII - 58 IIC Communication
 Detection of Start/Restart Condition and Stop Condition
When a start/restart condition is detected, SC3IICSTR.IIC3STRT is set to "1".
When the received slave address is equal to SCnAD, SC3IICSTR.IIC3STRT is cleared to "0" by setting data to
TXBUFn during the interrupt processing right after the slave address reception. When the received slave address
is not equal to SCnAD, SC3IICSTR.IIC3STRT is cleared automatically by hardware.
Confirm a busy flag to detect a stop condition.
Conditions to detect a start or a stop condition are shown in the table below.
Table:13.5.1 Start Condition/Stop Condition Detection Condition
 Busy Flag
IIC3BUSBSY is set when a start condition is detected on the IIC bus and is cleared when a stop condition is
detected. It is possible to check that IIC communication is executed between devices on IIC bus.
 ACK/NACK Transmission and Detection
When the LSI receive data, select ACK/NACK transmission with SCnMD3.IIC3ACKO.
When the LSI send data, confirm that ACK/NACK is received with SCnMD3.IIC3ACKO.
 First Bit Specification for Transfer
First bit for transfer can be selected. Select MSB first or LSB first with SCnMD0.IIC3DIR.
Start Condition
"High" period of SCLn ≥ (SCnCLK period) × 3
SDAn setup time ≥ (SCnCLK period) × 2
SDAn hold time ≥ (SCnCLK period) × 2
Stop Condition
"High" period of SCLn ≥ (SCnCLK period) × 3
SDAn setup time ≥ (SCnCLK period) × 2
SDAn hold time ≥ (SCnCLK period) × 2
SCL "High" period
SCLn
SDAn
holdsetup
SCL "High" period
SCLn
SDAn
holdsetup