Penlon Prima 460 - Anaesthetic Gas Scavenging System; Breathing System; After Cleaning

Prma 460 95 User Manual
Dsplay screen surface
AUTION
Do not apply excessve pressure to the dsplay screen
lean the dsplay screen wth soap-based santsng wpes Use a
soft cloth only Do not use harsh abrasve cleanng agents
8.2.2 Anaesthetic gas scavenging system
lean wth a damp cloth soaked n mld detergent Wpe off the
remanng detergent wth a dry lnt free cloth
8.2.3 Breathing system
The table shows the methods of cleanng, dsnfectng or
sterlsaton of ndvdual components
NOTE
If a Masmo Nomolne ISA AX+ or OR+ Module s ftted, refer to
Appendx 7
Part Method Detals Lfe cycles
O sensor (fuel cell sensor type), and
as/electrcal nterface unt mounted on
the rear of the absorber
leanng
Wpe wth mld detergent, dry wth
a lnt-free cloth
All parts of the breathng crcut,
except
1 The O sensor (fuel cell sensor type)
2 The gas/electrcal nterface unt
mounted on the rear of the absorber
Dsnfectng Wash wth mld detergent, soak for
30 mnutes n 30-41° detergent
(PH 70-105)
All parts of the breathng crcut, except
1 The O sensor (fuel cell sensor type)
2 The arway pressure gauge
3 The gas/electrcal nterface unt
mounted on the rear of the absorber
Sterlsaton
Autoclave at a maxmum
temperature of 121° for a
mnmum of 15 mnutes and a
maxmum of 30 mnutes
25 mnmum
Dsnfecton
Breathng system hoses and other components must be
dsnfected to the manufacturer’s recommended methods
Heat and mosture exchanger (HME)
An effectve, new heat and mosture exchanger wth a bacteral
flter should be used for every patent
8.2.4 After cleaning
Make sure that all cleanng agent resdues are removed after
cleanng
Allow all surfaces to dry thoroughly before clncal use
User Maintenance