P a g e | 58 P o o l C o p M a n u a l : V 4 2 EN
www.poolcop.com PCFR
Auxiliaries
Program auxiliary timers, and set them as slaved to run with the pump only, or on specific day.
Whenever quitting the AUXILIARIES menu, PoolCop checks and adjust the status of the pump and auxiliaries, and switches them
ON or OFF as required to match programmed running times.
AUX channels operate in the same manner, but some channels may be required for specific functions.
Note: Aux 8 to Aux 15 only available with PoolCop Extension Module.
Set ON time HH:MM in timer and pulse modes,
Set OFF time HH:MM in timer mode,
duration in pulse mode
Slave AUX to filtration; the auxiliary will only be ON if the
valve is in FILTER or BYPASS and the pump is ON.
Set AUX to operate on selected days of the week.
If PoolCop is managing a multispeed pump, AUX 1 is not
available
AUX 2 functionality is the same as AUX 1.
AUX 3 functionality is the same as AUX 1.
AUX 4 functionality is the same as AUX 1.
AUX 5 functionality is the same as AUX 1.
if a waste valve is configured, AUX 5 is not available.
AUX 6 functionality is the same as AUX 1.
If ORP Control is installed, AUX 6 is not available
AUX 8 functionality is the same as AUX 1.
AUX 9 functionality is the same as AUX 1.
AUX 10 functionality is the same as AUX 1.
AUX 11 functionality is the same as AUX 1.
AUX 12 functionality is the same as AUX 1.
AUX 13 functionality is the same as AUX 1.
If Jetstream is configured, Aux13 is not available
AUX 14 functionality is the same as AUX 1.
If Pool cover is configured, Aux14 is not available
AUX 15 functionality is the same as AUX 1.
If Pool cover is configured, Aux15 is not available
Auxiliaries
Aux 1
Id
Mode
ON
OFF/Dur
Slave
Day Of Week
Speed ctrl
Aux 2
See Aux1
Aux 3
See Aux1
Aux 4
See Aux1
Aux 5
See Aux1
Waste Valve
Aux 6
See Aux1
ORP
Aux 8
See Aux1
Aux 9
See Aux1
Aux 10
See Aux1
Aux 11
See Aux1
Aux 12
See Aux1
Aux 13
See Aux1
Jet Stream
Aux 14
See Aux1
PoolCover
Aux 15
See Aux1
PoolCover
To Next Page
Loading...