PoolCop Evolution - Calibrate Ph

P o o l C o p M a n u a l : V 4 2 EN P a g e | 89
www.poolcop.com PCFR
Calibrate pH
Calibrate pH to a known value
pH C A L I B R A TION
Ref pH
: 7.00
Confirm Ref pH
The press
SELECT to calibrate
S E L E C T
QUIT
Carry out a calibration procedure for the pH sensor.
The calibration procedure is described in the MAINTENANCE MANUAL (procedure
SMU_07_EN) downloadable on our internet website www.poolcop.com in RESOURCES
/DOWLOADS section.
Text: pH Calibration
Default: NO
Entries: YES;
NO
NOTE:
During the calibration process, PoolCop compares the "offset" of the probe to the signal that would be
delivered by a perfect probe. This offset is essentially related to wearing.
If the offset is too large, calibration is not possible.
It is then necessary to check that the reference pH is correct. If this is the case, the probe must be replaced.