PoolCop Evolution - Equipment

P a g e | 100 P o o l C o p M a n u a l : V 4 2 EN
www.poolcop.com PCFR
Equipment
Allows you to define the Pool
Cover, Jetstream settings
EQU I P M E N T
Pool Cover
Jetstream
S E L E C T
QUIT
NOTE:
These functionalities are only available if an XM8 Extended Module is installed and if the required Aux
outputs and Inputs are free to used.
Pool Cover
Set pool cover parameters
POO L C O V E R
Installed
: YES
Setting Open
Setting Close
Setting Position
S E L E C T
QUIT
WARNING:
Remote control of a pool cover can cause severe injury.
The user MUST ALWAYS have the pool in direct view when manoeuvring the cover and during opening or
closing operations. The pool must be monitored at all times during the operation of the pool cover to
ensure that no person is in the pool or enters the pool.
The remote control of the pool cover is reserved for maintenance operations carried out by an authorized
technician.
5.6.6.1.1 Installed
If INSTALLED: YES, PoolCop will be able to control the pool cover opening and
closing
If set to NO, the pool cover (if any) will be operated manually.
Text: Installed
Default: NO
Entries: YES;
NO
5.6.6.1.2 Opening setting (Aux14 settings)
When pool cover function is
installed, Aux14 (Open
command) is preconfigured in
pulse mode with 2 minutes
pulse duration. These settings
can be changed from this
view. Duration should be long
enough to allow full cover
operation from closed to
open.
AU X14 : R srv'd C o v e r
Mode
: Pulse
ON
: 00:00
Duration
: 00:02:00
S E L E C T
QUIT