P o o l C o p M a n u a l : V 4 2 EN P a g e | 91
www.poolcop.com PCFR
Freezing Protection
Activate or deactivate freezing protection.
When freezing risk is detected, either internally or externally (if installed) filtration is
run for at least 30 minutes.
Text: Protect Frz
Default: YES
Entries: YES,
NO
CAUTION:
PoolCop freezing protections can only assist in the protection of equipment. PoolCop cannot guarantee that
damage will be avoided under all circumstances, as this depends on many factors.
No responsibility will be accepted for damage caused due to freezing.
NOTE:
When freezing risk is detected and filtration started, the pump CANNOT be stopped until the temperature
detected is higher than the protection setting, or the Protection Antifreeze is switched OFF in the Pool Data
menu.
NOTE:
The freezing risk alerts are always active, even with freezing protection OFF.
NOTE:
Multispeed pumps are started on speed #1, supposedly the lowest speed.
Filtration Reduction when pool cover is detected closed
To be effective, this functionality assumes the connection of pool cover, or mobile floor limit switch to a PoolCop input. (see 5.6.4
Inputs). Depending if pool is configured with a single or multi-speed pump, reduction strategy is different:
5.6.1.5.1 Filtration time reduction (single speed pump)
Select the reduction percentage you want to apply to the filtration duration (Apply
only to ECO+ mode) when the cover is closed.
Text: Cover Reduc
Default: 30%
Entries: 0% - 70%
5.6.1.5.2 Pump speed reduction (multi speed pump)
Select the desired pump speed (apply to every filtration mode) when the cover is
closed. This speed will replace the normal Cycle 1 or Cycle 2 preselected speeds as
long as the cover is closed.
If value is 0, no change will occur when the cover state change.
Text: Cover speed
Default: 0
Entries: 0 - 8
Selecting the type of pool automatically configures some functions:
CLASSIC – the valve reverts to a “safe” Filter position whenever filtration is
inactive. Water level control is standard.
INFIN.A – the valve reverts to a “safe” Filter position whenever filtration is
inactive. Water level control is adapted to suit an infinity pool.
INFIN.B – the valve reverts to a “safe” Closed position (to prevent the pool
draining into the buffer tank with the pump OFF) whenever filtration is
inactive. Water level control is adapted to suit an infinity pool.
SPA – the valve reverts to a “safe” Filter position whenever filtration or other
functions are inactive, and there is no volume correction in ECO mode.
Text: Pool type
Default: classic
Entries: classic;
infini.A ;
infini.B ;
Spa
NOTE:
Changing the Pool Type affects the safe valve position as well as the way that water level control functions.
Be sure to read and fully understand the implications prior to changing this setting.
To Next Page
Loading...